An AFM, XPS and electrochemical study of molecular electroactive monolayers formed by wet chemistry functionalization of H-terminated Si(1 0 0) with vinylferrocene

Molecular electroactive monolayers have been produced from vinylferrocene (VFC) via light-assisted surface anchoring to H-terminated n- and p-Si(1 0 0) wafers prepared via wet chemistry, in a controlled atmosphere. The resulting Si-C bound hybrids have been characterized by means of XPS and AFM. Their performance as semiconductor functionalized electrodes and their surface composition have been followed by combining electrochemical and XPS measurements on the same samples, before and after use in an electrochemical cell. White-light photoactivated anchoring at short (1 h) exposure times has resulted in a mild route, with a very limited impact on the initial quality of the silicon substrate. In fact, the functionalized Si surface results negligibly oxidized, and the C/Fe atomic ratio is close to the value expected for the pure molecular species. The VFC/Si hybrids can be described as (η⁵-C₅H₅)Fe²⁺(η⁵-C₅H₄)-CH₂-CH₂-Si species, on the basis of XPS results. Electrochemical methods have been applied in order to investigate the role played by a robust, covalent Si-C anchoring mode towards substrate-molecule electronic communication, a crucial issue for a perspective development of molecular electronics devices. The response found from cyclic voltammograms for p-Si(1 0 0) functionalized electrodes, run in the dark and under illumination, has shown that the electron transfer is not limited by the number of charge carriers, confirming the occurrence of electron transfer via the Si valence band. The hybrids have shown a noticeable electrochemical stability and reversibility under cyclic voltammetry (cv), and the trend in peak current intensity vs. the scan rate was linear. The molecule-Si bond is preserved even after thousands of voltammetric cycles, although the surface coverage, evaluated from cv and XPS, decreases in the same sequence. An increasingly larger surface concentration of Fe³⁺ at the expenses of Fe²⁺ redox centers has been found at increasing number of cv’s, experimentally associated with the growth of silicon oxide. Surface SiO⁻ groups from deprotonated silanol termination, induced by the electrochemical treatments, are proposed as the associated counterions for the Fe³⁺ species. They could be responsible for the observed decrease in the electron transfer rate constant with electrode ageing.     

Effect of induced shielding current transmission in longitudinal direction on levitation force of melt grown single-domain YBa_2Cu_3O_(7-x) cylindrical superconductor

YBa2Cu3O7-x (YBCO) bulk is one of the most important high temperature superconducting materials for magnetic levitation applications, because it has a high magnetic irreversibility field Hirr at liquid nitrogen temperature, and can grow into large grains. The levitation force of YBCO bulk is proportional to the critical current density (Jc) and grain radius (r)[1], so higher Jc and r are appreciated for YBCO bulks to achieve higher levitation force. Now single-domain YBCO bulks up to s…     

Synthesis and characterization of a polyfluorene containing carbazole and oxadiazole dipolar pendent groups and its application to electroluminescent devices

We have synthesized a blue‐light‐emitting polyfluorene (PF) derivative ( PF‐CBZ‐OXD ) that presents bulky hole‐transporting carbazole and electron‐transporting oxadiazole pendent groups functionalized at the C‐9 positions of alternating fluorene units. The results from photoluminescence and electrochemical measurements indicate that both the side chains and the PF main chain retain their own electronic characteristics in the copolymer. An electroluminescent device incorporating this polymer as the emitting layer was turned on at 4.5 V; it exhibited a stable blue emission with a maximum external quantum efficiency of 1.1%. Moreover, we doped PF‐CBZ‐OXD and its analogue PF‐TPA‐OXD with a red‐light‐emitting iridium phosphor for use as components of phosphorescent red‐light emitters to investigate the effect of the host's HOMO energy level on the degree of charge trapping and on the electrophosphorescent efficiency. We found that spectral overlap and individual energy level matching between the host and guest were both crucial features affecting the performance of the electroluminescence devices. Atomic force microscopy measurements indicated that the dipolar nature of PF‐CBZ‐OXD , in contrast to the general nonpolarity of polydialkylfluorenes, provided a stabilizing environment that allowed homogeneous dispersion of the polar iridium triplet dopant. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2925–2937, 2007     

奇妙的惯性力

实际的参考系都不是惯性系，因此必须考虑惯性力．     

Fully developed mixed convection in horizontal and inclined tubes with uniform heat flux using nanofluid

Fully developed laminar mixed convection of a nanofluid consists of water and Al₂O₃ in horizontal and inclined tubes has been studied numerically. Three-dimensional elliptic governing equations have been solved to investigate the flow behaviors over a wide range of the Grashof and Reynolds numbers. Comparisons with previously published experimental and numerical works on mixed convection in a horizontal and inclined tube are performed and good agreements between the results are observed. Effects of nanoparticles concentration and tube inclinations on the hydrodynamics and thermal parameters are presented and discussed. It is shown that the nanoparticles concentration does not have significant effects on the hydrodynamics parameters. Heat transfer coefficient increases by 15% at 4 Vol.% Al₂O₃. Skin friction coefficient continually increases with the tube inclination, but the heat transfer coefficient reaches a maximum at the inclination angle of 45°.     

Calculation of Normal Vibrations of Chlorin by the Method of Density Functionals

Using the DFT/B3LYP method with a 6-31G(d) basis set, the structure, normal vibration frequencies, and the absolute band intensities in the IR spectra of the chlorin molecule and its four symmetric isotopomers have been calculated. Scaling of the force field by the Pulay method in independent and natural coordinates has been carried out. A method for obtaining effective force fields without using experimental data on the fundamental vibration frequencies is proposed. By comparing the vibration modes and constructing special matrices, complete assignment of the fundamental frequencies of porphin and chlorin has been carried out. It has been shown that the majority of porphin macroring vibrations upon pyrrolenine ring hydrogenation are frequency-characteristic and only 12 vibrations change considerably. A frequency correlation with regard for the mode transition between chlorin and all its isotopomers under consideration has been established. Comparative analysis of the force fields of porphin and chlorin in dependent natural coordinates has revealed the unique nonlocal character of the change in force constants of the macroring upon hydrogenation of one pyrrolenine ring. Modeling of the IR spectra of chlorin and its isotopomers has been performed. Assignment and interpretation of the normal vibrations of the molecules under consideration have been carried out.     

光电对抗在现代防空作战中的应用与展望

在综述光电对抗内涵的基础上，论述光电对抗在现代战争作战平台中的具体应用，并着重从电子战的角度论述了光电对抗在现代防空作战中的最新应用。最后指出光电对抗技术在未来电子战中的作用和发展方向。     

In-Situ Intrinsic Interface Strength Measurement at Elevated Temperatures and its Relationship to Interfacial Structure

A previously developed laser spallation technique has been modified to measure the tensile strength of thin film interfaces in-situ at temperatures up to 1100°C. Tensile strengths of Nb/A-plane sapphire, FeCrAl/A-plane sapphire and FeCrAlY/A-plane sapphire were measured up to 950°C. The measured strengths at high temperatures were substantially lower compared with their corresponding strengths at ambient temperature. For example, at 850°C, the interface tensile strength for the Nb/sapphire (151 ± 17 MPa), FeCrAl/sapphire (62 ± 8 MPa) and FeCrAlY/sapphire (82 ± 11 MPa) interface systems were lower by factors of approximately, 3, 5, and 8, respectively, over their corresponding ambient values. These results underscore the importance of using such in-situ measured values under operating conditions as the failure criterion in any life prediction or reliability models of such coated systems where local interface temperature excursions are expected. The results on alloy film interfaces also demonstrate that the presence of Y increases the strength of FeCrAl/Al₂O₃ interfaces.     

过渡金属表面γ-氨丙基三甲氧基硅烷膜的研究

本文对在过渡金属铁、镍电极表面制备得到的γ-氨丙基三甲氧基硅烷(γ-APS)膜进行了研究。实验中对硅烷膜用X-射线光电子能谱(XPS)、现场表面增强拉曼散射光谱(SERS)和原子力显微镜(AFM)进行了表征。X-射线光电子能谱(XPS)的结果发现存在两个N1s峰,表明γ-APS膜中的氨基有两种存在方式:自由氨基和质子化氨基。实验中还发现现场表面增强拉曼散射光谱(SERS)是研究金属/γ-APS体系中界面层结构非常有效的手段,SERS结果表明硅醇羟基和氨基发生了竞争吸附,且γ-APS分子在外加电位等条件的影响下吸附状态会发生一定变化。原子力显微镜(AFM)的表征结果在微观上显示电极表面的γ-APS膜上形成了一种较规则的微孔结构,这种结构可能与基底的性质有关。     

Reference values for drag and lift of a two‐dimensional time‐dependent flow around a cylinder

This paper presents a numerical study of a two‐dimensional time‐dependent flow around a cylinder. Its main objective is to provide accurate reference values for the maximal drag and lift coefficient at the cylinder and for the pressure difference between the front and the back of the cylinder at the final time. In addition, the accuracy of these values obtained with different time stepping schemes and different finite element methods is studied. Copyright © 2004 John Wiley & Sons, Ltd.